System requirements and description, System requirements – BLUESHAPE BSMon v3.0 User Manual
Page 3
This tool is designed for remote assistance. The battery status can be exported at any time to Blueshape® support
service for battery pack analysis. On the other hand, our support service can prepare special settings when required that
can easily be uploaded in the battery to customise its behaviour.
Through the
it is possible to graphically monitor the battery behaviour in real time and perform battery tests
with performance analysis. The logged data is accurate (
±1mV, ±1mA) and can be used for extensive laboratory
investigation of the battery.
System Requirements and description
System Description:
The system consists of these three main parts:
1.
the BSMon main unit (interface between PC and Battery)
2.
a special cable
3.
the computerized battery analyzer (called CBA unit)
The main unit provides the USB connectivity with the PC and accepts the installation of the battery through a V-lock
interface. It connects and drives the CBA unit by means of a special multicore cable.
Additionally the main unit can be used as a standalone battery reader and, if installed on any V-Lock enabled device
together with a battery, permits tracking down the battery behaviour while in use.
BSMon can efficiently read and test both non-Blueshape® batteries and non V-Lock batteries: in this case a special cable
with banana plugs must be used to connect the battery to be analyzed with the main unit through the lateral red and black
sockets.
System requirements for software installation:
OS: Windows 2000/ XP/ Vista/ 7/ 8 either 32bit and 64bit (the drivers for the USB interface may not work properly
under older OS such as ME, 98, 95)
Minimum configuration: Pentium 3 or higher, 128Mb RAM or greater, 25MB HD disk space
USB 1.0 port or greater
Created with the Standard Edition of HelpNDoc: