Bowers Group Advanced Electronic/Air Column PC-2200 - Manual (Page 4)

PC-2200
BOWERS METROLOGY page 4 /32 version 2.06 -E
CHAPTER 1. INTRODUCTION
1.1 GENERAL INFORMATIONS
-
The column PC-2200 is an instrument system that measures and displays “ID, OD, Length related
measurements such as misalignment, and others” in automotives, machines, electrical and
electronic parts, and determines whether the measured results are acceptable or not.
-
The user can identify the measurement values correctly and easily as the display is made on a
3-Color LED Bar (green, orange, red) and a DOT MATRIX LED (8 characters) mounted in the front
side.
-
The Status panel, positioned on the front bottom side, shows the current operating status in regards
to the unit system (mm/inch) and operating sets (M1, M2, M3, M4) using 12 LED’s (green).
-
The Keypad, consists of 9 membrane switches mounted below the Status panel, performs the user
program such as the system setup. The user can build the program environment that can satisfy the
user’s requirements to the maximum through the Keypad operation such as selecting the menu in
easy and free way and setting up the required variables.
-
The rear upper side is configured as the AC power switch, Fuse holder, AC power inlet and Aux.
power supply, and therefore, it can use several units of PC-2200 through connecting with only one
unit of power supply. The AC power of AC 110/230 V and 50/60 Hz is applied. You can select the
power source of 110V/230V (default : 110V) by inserting the connector on the DC power PC board
that is fixed on the upper side of the system inside.
-
With the 5 external interfaces on the rear center side, the column can be connected to another
column, PC, Printer, PLC or CNC.
-
You can use the HBT, LVDT and CAPACITIVE probes as electronic system or AIR probes through
the analog board on the rear bottom side. You should install the analog board (PCB) dedicated by
the type of probe.
- The PC-2200 is an integrated high quality measurement system that performs various
measurements and display functions such as inter-channel operations up to 4 channels and dynamic
mode in addition to the simple displays of measurement values.