Calculated Industries 6020 v3.1 - Manual (Page 11)

9 – User’s Guide
Programming Mode
The Scale Master Classic allows you to preset
frequently used values, including:
• Custom Scales (3 Imp/3 Met)
•
Height value
The following keys are used in programming mode:
[M1+] Increases the selected digit/units.
[SUBTRACT/COUnT] Decreases the
selected digit/units.
[SCALE] Advances the cursor to the next
place to the right. Exits and saves changes if
pressed while right-most digit is selected.
[MODE] Moves the cursor back to the next
place to the left.
[RESET] Exits without saving.
Setting Custom Scales
You can program and store six Custom Scales:
three in Imperial mode and three in Metric mode.
You can set a custom scale two ways: by “rolling in”
a known distance or by entering the exact distance.
Rolling a Custom Scale
1) Press [MODE] until #
open
(# being a
number 1-3) appears in the scale box display.
2) Press [SUBTRACT/COUnT] + [SCALE] .
“
roll
” will appear in the main display.
3) Roll desired distance. “
rolling
” now
appears in the main display.
Note: For greater accuracy, roll the longest known
distance you have on your plan.
4) Press [SCALE] . The annunciator will begin
(Cont’d)