Calculated Industries 6020 v3.1 - Manual (Page 12)

10 – Scale Master
®
Classic
flashing “
ft in
” for Imperial Mode or “
m
”
for Metric Mode.
5) If you do not want to change the units,
skip to step 6. If you want to change the
units, press [M1+] until you reach the
desired units.
6) Press [SCALE] to begin setting the scale distance.
The left-most digit will begin flashing.
Press:
[M1+] to increment the selected digit,
[SUBTRACT/COUnT] to decrement,
[SCALE] to advance to the next digit,
[MODE] to move back one digit.
7) Continue to press [SCALE] until all digits
are set and the display returns to zero. The
scale is now stored.
Entering a Custom Scale
1) Press [MODE] until #
open
(# being a
number 1-3) appears in the scale box display.
2) Press [SUBTRACT/COUnT] + [SCALE] .
“
roll
” will appear in the main display.
3) Press [SCALE] again. The annunciator will
begin flashing “
ft in
” for Imperial Mode.
The left-most digit flashes for Metric Mode.
Note: If in Metric Mode, skip to Step 5.
4) If you want to change the units, press
[M1+] until you reach the desired unit.
Then press the [SCALE] key to begin
setting the distance. The left-most digit
will begin flashing.
5) In Imperial mode, the scale will be one inch
equals the distance you entered. In Metric
mode, entered scales are direct ratios.
(Cont’d)