Calculated Industries 6270 User Guide - Manual (Page 37)

CIRCLE RADIUS
CIRCLE DIAMETER
4. Upon pressing
the [MEASURE]
key in Step 3, the
Circle measurement
was automatically
completed and
the Circle Area
displayed. Once a
Circle measurement
is completed, press
the D-Pad down
[6] to display Circle
Perimeter, Circle Wall
Area, Circle Volume
and stored Height.
Continuous presses
of the D-Pad down
[6] or up [5] will
scroll back and forth
through the values.
* Circle Wall Area, Circle
Volume and Height do
not display if a Height
has not been set. For
this example, a Height
of eight Feet was used.
(See Setting a Height
section for instructions
on setting a Height.)
4
5. Press the D-Pad
right [4] to display
the Circle Radius
and Circle Diameter.
Continuous presses
of D-Pad right [4]
will scroll through
these values.
Repeated presses of
the D-Pad left [3] will
scroll back through
these values.
5
CIRCLE AREA
CIRCLE PERIMETER
CIRCLE WALL AREA*
HEIGHT*
CIRCLE VOLUME*
If you have an actual Diameter, follow steps 1 and 2
then replace step 3 with a press of the [CLOSE+] key.
Diameter
U
SER’S
G
UIDE
— 35