Calculated Industries 6270 User Guide - Manual (Page 44)

PC INTERFACE
The Ultra Scale Master Pro with PC Interface can be used to send displayed
numerical values from your Puck directly to the selected estimating, spreadsheet,
word processing, or text editing program on your PC. It can also be used to send
data to digitizing programs while in Digitizer Mode (see Digitizer Mode section).
The PC Interface is a ten-foot long
USB cable specially designed for
use with the Ultra Scale Master Pro.
There is no driver software needed.
Simply follow the instructions
below to connect your
Ultra Scale Master Pro
to your PC.
SYSTEM REQUIREMENTS:
— Windows 2000, XP, Vista Operating Systems — One USB port
Note: When connected to a PC, a small PC-shaped icon will appear at the upper right side of the Puck’s display, indicating a valid connection has
been established. This icon will be displayed only when the USB cable is securely connected to the Puck and the PC. The USB cable is specially
designed for use only with the Ultra Scale Master Pro. The Ultra Scale Master Pro cannot be used with any other USB cable.
42 — U
LTRA
S
CALE
M
ASTER ®
P
RO
2. Insert the large
end of the USB
cable into the USB
port on the PC.
1. Insert the small end of the USB
cable into the USB plug located on the
bottom end of the Puck.