Calculated Industries 6270 User Guide - Manual (Page 41)

A Height can be set to calculate Wall Areas and Volumes which are displayed using the D-Pad once an area measurement has
been completed. If no Height is stored, Wall Area and Volume are not displayed. The following example is shown in Imperial
Mode. The displays will be slightly different if in Metric Mode.
SETTING A HEIGHT
1. Press [SET] then [HEIGHT] to begin entering a Height.
2. The displayed units begin fl ashing, indicating that they
are ready to be changed. Press [UNITS] to scroll through
the available units.*
3. Use D-Pad right [4] to begin value entry mode. The
selected digit begins fl ashing, indicating that it is ready
to be changed. Use D-Pad right [4] and left [3] to move
between the digits.
4. Use D-Pad up [5] or down [6] to increase or decrease the
selected digit.
5. To store your Height, press [SET] or [HEIGHT]. To confi rm
the Height has been set, “Ht Set” is displayed for one second.
* In Imperial Mode, only the following units are available:
Feet-Inch, Feet and Inches.
In Metric Mode, only the following units are available: Meters,
Centimeters and Millimeters.
Note: Press [HEIGHT] to view a stored Height. A Height is only
cleared if a new Height is stored, an All Clear or Reset is performed,
or if the unit is switched between Imperial and Metric Modes.
U
SER’S
G
UIDE
— 39