Calculated Industries 6270 User Guide - Manual (Page 40)

SETTING AN ENTERED CUSTOM SCALE (IMPERIAL MODE)
1. Press [MODE] until “CUST” is displayed. Press [SCALE]
to scroll through the four available Custom Scales. For
this example, Custom Scale-1 is used.
2. Press [SET] then press [SCALE] [SCALE] to begin
entering the Custom Scale.
3. The displayed units begin fl ashing, indicating that they
are ready to be changed. Press [UNITS] to scroll through
the available units.*
4. Use D-Pad right [4] to begin value entry mode. The
selected digit begins fl ashing, indicating that it is ready
to be changed. Use D-Pad right [4] and left [3] to move
between the digits.
5. Use D-Pad up [5] or down [6] to increase or decrease the
selected digit.
6. To store the Custom Scale, press [SET] or [SCALE]. To
confi rm the scale has been set, “Scl Set” is displayed for
one second. Entered Custom Scales display the Inch-to-Feet
scale ratio instead of “OPEN” or “SET” (e.g. 1:15 for 1 Inch =
15 Feet).
* In Imperial Mode, only the following units are available: Feet-Inch, Feet and Inches
38 — U
LTRA
S
CALE
M
ASTER ®
P
RO