Boss Audio Systems SP-505 - Manual (Page 37)

37
Chapter 2. Using the internal effects
2
13. OVERDRIVE DRIVE TONE LEVEL
Mildly distorts the sound. Adjusts the depth of distortion. Adjusts the tonal character. Specifies the volume.
14. FUZZ DRIVE TONE LEVEL
Adds harmonics and distorts the
sound. Adjusts the depth of distortion. Adjusts the tonal character. Specifies the volume.
15. WAH SENS FREQ (Frequency) PEAK
Produces a “wah” effect Adjusts the sensitivity of the
Wah effect. Adjusts the pitch of the effect
sound. Adjusts the wah’s peak volume.
16. OCTAVE -2OCT (-2 Octave Level) -1OCT (-1 Octave Level) D.LEVEL (Direct Level)
Adds sound octaves lower. Adds sound two octaves lower
than the original sound. Adds sound one octave lower
than the original sound. Adjusts the volume level of the
direct sound.
17. COMPRESSOR SUSTAIN ATTACK LEVEL
Makes the volume more consis-
tent. Adjusts the amount of the com-
pressor effect that is applied. Adjusts the sound's attack. Specifies the volume.
18. EQUALIZER LOW MID (Middle) HIGH
Adjusts the volume level for
each individual frequency
range. Adjusts the volume of the low
frequency range. Adjusts the volume of the
midrange. Adjusts the volume of the high
frequency range.
19. LO-FI PROCESSOR SMPL RTE (Sample Rate) BIT FILTER
Gives the sound a “low-fidel-
ity” character. Adjusts the sampling frequency.
(*2) Adjusts the bit count. Adjust the sensitivity with
which the filter will be affected.
20. NOISE GENERATOR COLOR QUALITY LEVEL
Generates noise. Adjusts the tone of the hissing
noise. Sets how often the scratch noise
is produced. Adjust the volume level of the
hissing noise.
21. RADIO TUNING TUNING NOISE LV (Noise Level) FERQ RNG (Frequency Range)
Reproduces the sound being
played on the radio. Adjusts the degree of noise that
occurs when tuning a radio. Specifies the volume of the
noise. Adjusts the tonal character.
22. SLICER + FLANGER PTN (Timing Pattern) RATE FLANGER
Continuously cuts the sound.
Includes a flanger effect. Select a pattern to specify the
timing at which the sound will
be cut. (*3) Adjusts the length of the PTN
(Timing Pattern). (*4) Adjusts the degree of the flanger
effect.
23. RING MODULATOR FREQ (Frequency) E.LEVEL (Effect Level) D.LEVEL (Direct Level)
Creates a metallic sound quality. Adjusts the pitch of the metallic
sound. Adjusts the volume of the effect
sound. Adjusts the volume level of the
direct sound.
24. CHROMATIC P.S. PITCH 1 PITCH 2 BALANCE (Direct/Effect Balance)
Two-voice pitch shifter that
changes the pitch in semitone
steps. Changes Pitch 1 up or down one
octave in semitone intervals. Changes Pitch 2 up or down one
octave in semitone intervals. Adjusts the balance of the effect
sound and direct sound.
25. VOICE TRANSFORMER FORMANT E.LEVEL (Effect Level) D.LEVEL (Direct Level)
Processes human vocals to pro-
duce a variety of different
voices. Adjusts the vocal characteristics
(formant). Adjusts the volume level of the
effect sound. Adjusts the volume level of the
direct sound.
26. CENTER CANCELER L-R BAL (L-R Balance) LO BOOST (Low Boost) HI BOOST (High Boost)
Eliminates the vocals and other
sounds located at the center. Finds the best point for deletion. Boosts the bass and other low-fre-
quency sounds located at the cen-
ter. Boosts the high-frequency
sounds.
DSP EFFECTS CTRL 1 CTRL 2 CTRL 3