Bunn FMD-5 - Manual (Page 24)

24
SERVICE (cont.)
DISPENSE SWITCHES (cont.)
7. Check for continuity across the terminals (top
right to top left; bottom right to bottom left) of the
dispense switch with the switch in the “ON” posi-
tion. Continuity must not present when the switch
is in the “OFF” released position.
If continuity is present as described, reconnect the
connector to the door interconnect wiring harness,
the switch is operating properly.
If continuity is not present as described, replace the
switch.
Removal and Replacement
1.
Open the dispenser door.
2. Remove the six #8-32 screws securing the bot-
tom door cover and remove cover.
3. Disconnect the wires on the dispense switch from
the door interconnect wiring harness.
4. Compress the clips inside the door on the dis-
pense switch and gently push the switch through
the opening
5. Push the new switch into the opening and spread
the clips to hold the switch in the door.
6. Reconnect the wires to the dispense switch from
the door interconnect wiring harness.
7. Reinstall the door bottom cover using six #8-32
screws.
8. Refer to Fig. 14 when reconnecting wires.
FIG. 14 DISPENSE SWITCH TERMINALS
P1449
BLK
RED/WHI
WHI/BLK
RED/BLK
ORN/BLK
GRN/BLK
BLU/BLK BLK/WHI
RED
ORN
GRN/WHI
BLU
STATIONS
-1-
-2-
-3-
-4-
-5-
35135 012103