Bunn FMD-5 - Manual (Page 32)

32
J4
J1 J2
J3
J4
J1 J2
J3
SERVICE (cont.)
P2635
RINSE/RUN SWITCH
FIG. 25 RINSE/RUN SWITCH
Location:
The rinse/run switch is located on the lower center
of the whipper motor mounting panel.
Test Procedures:
1.
Disconnect the dispenser from the power source.
2. Check for continuity between the center left ter-
minal and left bottom terminal, also between the
center right terminal and the right bottom termi-
nal with the switch in the rinse position (upper).
Check for continuity across the center left termi-
nal and the top left terminal, also between center
right terminal and the top right terminal with the
switch in the run position (lower). Continuity must
not be present when the switch is in the center
position.
If continuity is present as described, the switch is
operating properly.
If continuity is not present as described, replace the
switch.
FIG. 26 RINSE/RUN SWITCH TERMINALS
P1644
GRY to Control
Board J2-2
GRN to Control
Board J2-9
WHI/GRY to Control
Board J2-3
BRN/BLK to
Main Harness
BLK from
Main Harness
BRN/BLK to
Main Harness
Removal and Replacement:
1.
Open the dispenser door.
2. Remove the facenut securing the run/rinse switch
to the whipper motor mounting panel.
3. Remove switch with wires attached from the back
side of the whipper motor mounting panel.
4. Disconnect the wires from the switch and dis-
card the switch.
5. Refer to Fig. 26 when connecting the wires to
the new switch.
6. Install new switch with wires attached through
the hole in the whipper motor mounting panel
and secure with facenut.
35135 012103