Dhcp connection – ClearCube I/Port Users Guide User Manual
Page 34
24 •
•
IP addresses
•
Subnet mask
•
Gateway
These values can be any value appropriate for your environment.
d. Click Apply and then click Reset in the Attention dialog box to reset the I9420.
e.
In the upper–left corner of the screen, click Options > Configuration to open the
Configuration window. Click Unlock on the lower–left portion of the window to
display the Unlock dialog box. Click OK to unlock the window (you should not need
to type a password).
f.
From the Session tab, select IP address in the Identify Peer by line. Specify the
following in the appropriate fields:
•
Identify Peer by—The V5120 IP address
•
Peer MAC Address—The V5120 MAC addresses (printed on a label on the side
of the blade)
g. Click Apply and then click OK to close the Configuration window. You can now
continue to provision the V5120 Dual Host card on the blade.
4. Provision the V5120 Dual Host card on the blade.
a.
Open a Web browser on a computer with a static IP address on the same subnet as the
the V5120 Dual Host card you are provisioning.
b. In your browser, type the IP address of the V5120 you specified in step
to open the
PCoIP Web interface.
c.
From the Log In page, click Log In (you should not have to type a password).
d. From the Network page, ensure that the Enable DHCP option is cleared. Specify the
following values for the V5120 card:
•
IP Address
•
Subnet Mask
•
Gateway
e.
Click Apply and then click Continue.
f.
Click Configuration > Session. Ensure that the Accept Any Peer option is clear. In
the Peer MAC Address line, type the MAC address of the I9420 I/Port (the MAC
address is on a label on the bottom of the I9420).
g. Click Apply and then click Continue.
h. Click Configuration > Monitor Emulation. Select the monitor emulation option for
both monitors (DVI 1 and DVI 2).
i.
Click Apply and then click Reset. The V5120 displays a power state message. Click OK.
5. Briefly press and hold the reset button on your blade to reset it. You can now start your
I9420 I/Port and click Connect to connect to your blade.
DHCP Connection
When connecting a blade and a I9420 on a network with a DHCP server, you can enable both
devices to accept a dynamic IP addresses.
Note:
Ensure that your chassis and I/Port are connected to a switch on a network with a
DHCP server.