ClearCube I/Port Users Guide - Manual (Page 47)

• 37
The A1410 blade does not support standby state. Briefly press the remote power (less than
four seconds) to perform a graceful shutdown, or soft power off.
I9420 does not support the hard reset option, or Hard-Power off (pressing and holding the
remote client power button for more than four seconds). In the V5120 configuration Web
page, click Permissions and then click Power. Ensure that Soft-Power off is selected. No
other option is supported.
The I9420 displays an Error: Value must be 0-FF or an Invalid
Peer MAC Address error message.
After configuring the I9420, the I/Port displays error messages about MAC addresses.
Resolution
You have changed the Connection Type to RDP, which is unsupported. From the V5120
configuration Web page, click Permissions and then click Sessions. Select PcoIP in the
Session Type drop-down menu.
The mass storage lockout (MSL) jumper in the blade does not prevent mass
storage devices from operating on the I9420.
The MSL feature is not implemented in December 2007 release.
Resolution
Use the Permissions tab on the I9420 and C7420 to enable MSL. From the V5120
configuration Web page, click Permissions and then click USB.
The default I/Port behavior is to permit all USB mass storage devices. You can add mass
storage devices to a list of prohibited devices can be added by class, vendor, or specific ID.
You can specify a password to access these screens.
If mass storage lockout (MSL) is enabled on a I9420 or C7420 I/Port in a Sentral
environment and I insert a USB device in the I/Port, an empty, gray dialog box is
displayed.
You can enable mass storage lockout through a blade's V5120 configuration Web page. When
you insert a USB device in the I/Port and the I/Port is in a direct connect mode, a gray dialog
box is displayed that says USB device is not authorized.
If the I/Port is in a Sentral environment and MSL is enabled, the dialog box displayed when
you insert a USB device does not contain any text.
Resolution
Remove the USB device to dismiss the dialog box.