Setting up connections, Direct connection – ClearCube I/Port Users Guide User Manual
Page 33
• 23
–
V5120 Dual Host card processor
•
Each PCoIP processor has an IP address, for a total of two IP addresses. Note that the IP
addresses of the PCoIP processors are not the same as the host’s (that is, the computer’s)
IP address.
You must provision PCoIP processors on blades and on I9420 I/Ports when deploying I9420s.
To provision an I9420, you must:
1. Determine the IP address structure for your environment and determine the IP addresses of
the blade, the V5120 Dual Host card, and the I9420 I/Port.
2. Configure the PCoIP processors on the I9420 and on the V5120 card that connects to the
thin client.
3. Establish a network connection between the I9420 and the V5120 card in a blade using
any of the following options:
–
Direct cable connection or connection through local Ethernet switch
–
DHCP connection
–
ClearCube Sentral
Setting up Connections
The following sections describe how to configure your I9420 I/Port and dual–monitor host
(blade). Connect the devices using the any of the following methods as appropriate for your
environment.
Direct Connection
To perform the following steps, you must have the IP and MAC address of the V5120 Dual
Host card in the host to which you are connecting. Default IP and MAC addresses are provided
in the following steps.
1. Ensure that you have connected devices as described in "
2. Connect the chassis and I9420 I/Port.
a.
Connect one end of a CAT5 or CAT6 Ethernet cable to the appropriate port on your
chassis.
•
R4300 chassis—Insert the cable in the Secondary Network port.
•
A3100 chassis—Insert the cable to the PCoIP port.
b. Connect the other end of the cable to the RJ-45 connector on the I9420.
3. Configure the I9420.
a.
Briefly press and hold the power button on the front of the I9420 to power it on. The
I9420 displays a dialog box.
b. In the upper–left corner of the screen, click Options > Configuration to open the
Configuration window. Click Unlock on the lower–left portion of the window to
display the Unlock dialog box. Click OK to unlock the window (you should not need
to type a password).
c.
In the Network tab, ensure that the Enable DHCP option is cleared. Specify the
following for the I9420 I/Port: