Metrohm 726 TP Backup - Manual (Page 5)

726 TP Backup
4 8.726.8007 Instructions for Use
2.2 Installation of the program
Windows 3.1x
Insert the installation disk of 726 TP Backup in the 3½“disk drive.
Start Windows 3.1x if you have not already done so.
Ÿ In the Windows Program Manager, choose the Run command from the File
menu.
Windows shows the dialog box Run.
Ÿ Enter a:setup in the Command Line box, press the Enter key.
Ÿ The ‘InstallShield Wizard’ will then guide you through the setup process.
Just follow the instructions on the screen.
Windows 95 / NT 4.0
Insert the installation disk of 726 TP Backup in the 3½“disk drive.
Start Win95/NT if you have not already done so.
Ÿ Click the Start button on the task bar and chose the Run option in the Start
menu.
Windows shows the dialog box Run.
Ÿ Enter a:setup in the Command Line box, press the Enter key.
Ÿ The ‘InstallShield Wizard’ will then guide you through the setup process.
Just follow the instructions on the screen.
2.3 Configuration of the 726 TP Backup program
Port settings
Start the 726 TP Backup program and open the Port Settings menu option in
the Configuration menu.
Switch on the 726 Titroprocessor. Switch to the dialog page Config. and then
Interfaces.
Warning:
The RS232 interface of the 726 Titroprocessor (RS232 Interface.1 or In-
terface.2) and the current RS232 interface of the computer must have the
same configuration.