2 deaerating the high pressure pump, Deaerating the high pressure pump – Metrohm 850 Professional IC AnCat MCS User Manual
Page 45
Advertising
■■■■■■■■■■■■■■■■■■■■■■
2 Installation
850 Professional IC – AnCat – MCS
■■■■■■■■
35
2.10.2
Deaerating the high pressure pump
The high pressure pump will only operate perfectly if the pump head con-
tains no more air bubbles. Therefore it must be deaerated during initial
start-up and after every change of eluent.
Caution
The high pressure pump must not be deaerated before the initial start-
up (see Chapter 3.1, page 66).
Deaerate the high pressure pump as follows (see Figure 19, page 36):
Advertising