Metrohm 882 Compact IC plus – Anion - Manual (Page 5)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ Table of contents
882 Compact IC plus – Anion ￭￭￭￭￭￭￭￭ III
Table of contents
1 Introduction 1
1.1 Instrument description ......................................................... 1
1.2 Intended use ......................................................................... 2
1.3 About the documentation ................................................... 3
1.3.1 Symbols and conventions ........................................................ 3
1.4 Safety instructions ................................................................ 4
1.4.1 General notes on safety ........................................................... 4
1.4.2 Electrical safety ........................................................................ 4
1.4.3 Tubing and capillary connections ............................................. 5
1.4.4 Flammable solvents and chemicals ........................................... 5
1.4.5 Recycling and disposal ............................................................. 5
2 Overview of the instrument 7
2.1 Front ...................................................................................... 7
2.2 Rear ........................................................................................ 8
3 Installation 10
3.1 About this chapter .............................................................. 10
3.2 Initial installation ................................................................ 10
3.3 Installation diagram ........................................................... 13
3.4 Setting up the instrument .................................................. 15
3.4.1 Packaging .............................................................................. 15
3.4.2 Checks .................................................................................. 15
3.4.3 Location ................................................................................ 16
3.5 Capillary connections in the IC system ............................. 16
3.6 Installations on the rear of the instrument ...................... 19
3.6.1 Transport locking screws ....................................................... 19
3.6.2 Leak sensor ........................................................................... 19
3.6.3 Drainage tubings ................................................................... 20
3.7 Capillary and cable feed-throughs .................................... 22
3.8 Eluent ................................................................................... 24
3.8.1 Connecting eluent bottle ....................................................... 24
3.9 High pressure pump ........................................................... 28
3.9.1 Capillary connections high pressure pump/purge valve ........... 28
3.9.2 Deaerating the high pressure pump ....................................... 30
3.10 Inline filter ........................................................................... 32
3.11 Pulsation absorber ............................................................. 33