6 connecting sensors, 1 connecting a generator electrode, 2 connecting an indicator electrode – Metrohm 851 Titrando User Manual
Page 40: Connecting sensors, Connecting a generator electrode, Connecting an indicator electrode, Figure 19
3.6 Connecting sensors
■■■■■■■■■■■■■■■■■■■■■■
32
■■■■■■■■
851 Titrando
3.6
Connecting sensors
The measuring interface contains the following measuring inputs:
■
Gen. for a generator electrode
■
Ind. for a double Pt electrode
■
Temp. for a temperature sensor (Pt1000 or NTC)
3.6.1
Connecting a generator electrode
Connect the generator electrode as follows:
1 Plug the electrode plug into the Gen. socket of the 851 Titrando.
Temp.
Gen.
Figure 19
Connecting a generator electrode
NOTE
The electrode cable is protected against accidental disconnection
of the cable by means of a pull-out protection. If you wish to pull
out the plug again, you will first need to pull back the outer plug
sleeve.
3.6.2
Connecting an indicator electrode
Connect the indicator electrode as follows:
1 Plug the electrode plug into the Ind. socket of the 851 Titrando.