Metrohm 851 Titrando - Manual (Page 41)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
851 Titrando
￭￭￭￭￭￭￭￭ 33
Figure 20 Connecting an indicator electrode
NOTE
The electrode cable is protected against accidental disconnection
of the cable by means of a pull-out protection. If you wish to pull
out the plug again, you will first need to pull back the outer plug
sleeve.
3.6.3 Connecting a temperature sensor
A temperature sensor of the Pt1000 or NTC type can be connected to the
Temp. connector.
Connect the temperature sensor as follows:
1 Insert the plugs of the temperature sensor into the Temp. sockets of
the 851 Titrando.
Temp.
Ind.
Figure 21 Connecting a temperature sensor