Metrohm 799 GPT Titrino - Manual (Page 214)

5.1. Setting up and connecting the instruments
799 GPT Titrino
210
5.1.4 Connection of a balance
The following balances can be connected to the RS232 output of the
Titrino:
Balance Cable
Sartorius MP8, MC1 6.2134.060
Shimadzu BX, BW 6.2125.080+6.2125.010
Settings on Titrino: balance SARTORIUS
Balance: elimiter CR+LF
Ohaus Voyager, Explorer,
Analytical Plus
from Ohaus: AS017-09 (Ohaus parts number)
Settings on Titrino: balance SARTORIUS
Balance: SET BALANCE
INTERFACE
BAUD RATE 9600
DATA BITS 8
PARITY none
STOP BITS 1
Mettler AB, AG (LC-RS25) in the scope of delivery of the balance
Mettler AM, PM 6.2146.020 + 6.2125.010
additionally from Mettler:
ME 47473 Adapter and ME 42500 hand switch or ME
46278 foot switch
Mettler interface 016 Cable in scope of delivery of interface 016: red lead
to pin 3, white lead to pin 7 of the 25-pin connector
+ 6.2125.010 25-pole/9-pole adapter
Mettler interface 011 or 012 6.2125.020 + 6.2125.010
Mettler AT 6.2146.020 + 6.2125.010
Mettler PG, AB-S 6.2134.110
Mettler AX, MX, UMX 6.2134.120
AND Models ER-60, 120, 180, 182
Models FR-200, 300
Models FX-200, 300, 320
with RS232 interface (OP-03)
6.2125.020 + 6.2125.010
Precisa, balances with RS232C-
interface
6.2125.080 + 6.2125.010
The balance type must be preselected at the Titrino with the
<CONFIG> key.
The weight is transferred as a number with up to 6 digits, sign and
decimal point. Units and control characters sent by the balance are
not transmitted.
With the aid of a special input unit supplied by the balance manufac-
turer, in addition to the weight identifications and methods can be