Barco D-ILA LX-5 - Manual (Page 11)

11
Rear
G
[DVI 1 to 4] Terminal
This is an input terminal for video signals. Connect it to
the video output terminal of the computer.
(
A Page 19, 21)
H Vent Hole
Warm air exits from the hole after cooling the projector.
CAUTION:
● Do not block the vent holes with papers, cloth, or soft
cushions. Doing so may cause heat to trap inside the
projector and result in fire or malfunction.
I Vent Hole (For Lamp)
Warm air exits from the hole after cooling the lamp.
J Main Power Supply Switch
Use this to turn ON/OFF the main power supply of the
projector unit.
K AC Power Input Terminal
Connect the supplied cord to this terminal.
L [STANDBY/ON] Indicator
Lit (Red) : When in the standby mode.
Lit (Green) : When power is supplied.
Blinking (Red) : When cooling down (cool down
mode). ( A Page 29)
Blinking (Green) : When the projected image is
temporarily hidden. ( A Page 29)
NOTE:
● For details on indicator displays during warnings, refer
to “Warnings Using Indicators”. (
A Page 47)
M
[LAMP] Indicator
This indicator lights up in yellow when the lamp time
exceeds 1400 hours.
NOTE:
● For details on indicator displays during warnings, refer
to “Warnings Using Indicators”. ( A Page 47)
● A lamp life message appears when the lamp time has
exceeded 1500 hours. ( A Page 46)
N [WARNING] Indicator
This indicator lights up in red when abnormality occurs on
this projector. For details, refer to “Warnings Using
Indicators”. (
A Page 47)
O [OPERATE I/ B] Button
Pressing this button for one second or longer when in the
standby mode (main power supply is ON) turns on the
power of the projector unit. Pressing it for one second or
longer when the power is ON switches the projector to
the standby mode.
P
[RS-232C] Terminal
This is the RS-232C interface-specific terminal. This
projector can be controlled by connecting it to a computer
using a RS-232C cable.
Q [LAN] Terminal
Enables control of this projector using a computer that is
connected to the network.
R [USB] Terminal
Enables control of this projector by connecting it to a
computer.
OPERATE I/ B
DVI 3
USB
LAN
RS-232C
STANDBY/ON
CONTROL
LAMP
WARNING DVI 4
DVI 1
DVI 2
G H I J K
L M N O
P
Q
R
Exhaust air
LX-5_EN.book Page 11 Friday, July 4, 2008 9:35 AM