Barco D-ILA LX-5 - Manual (Page 24)

24
Network Settings
Set the IP address for this projector. There are 2 methods to set the IP address.
Ⅵ Assigning a static IP address
Ⅵ Assigning an IP address from the DHCP Server
Assigning a static IP address
The AIP Address SettingB of this projector is set to AStatic IPB (the DHCP client function is OFF) by default.
Upon turning on the power, this projector starts running with the following IP address.
IP Address : 192.168.0.2
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.0.254
Ⅵ IP address setting at the computer
Set the computer to an IP address that enables communication with this projector.
1
Click AStartB and select AControl PanelB
2
Double click ANetwork ConnectionsB
3
Right-click on ALocal AreaB and select APropertiesB
● Check to ensure that the AClient for Microsoft NetworksB and AInternet Protocol(TCP/IP)B check boxes are selected.
4
Select AInternet Protocol(TCP/IP)B and click APropertiesB
5
Set the IP address
6
Click AOKB on the ALocal Area Connection PropertiesB screen
IP Address Settings
A
B
C
D
E Click AOKB
Set the AIP addressB
(For example, use 192.168.0.100 when LX-5 is in its default
settings)
NOTE:
● Make sure that you take note of the original IP address
before altering.
● When setting, ensure that a duplicate IP address is not
used within the same network environment.
Set ASubnet maskB
Set to a value that is appropriate for the setting operation.
Clarify with the network administrator if you have any queries.
(Use 255.255.255.0 when the camera is in its default settings)
Select AUse the following IP addressB
When a ADefault gatewayB is present, make use of the IP
address (e.g., 192.168.0.254)
LX-5_EN.book Page 24 Friday, July 4, 2008 9:35 AM