Metrohm 859 Titrotherm - Manual (Page 23)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
859 Titrotherm ￭￭￭￭￭￭￭￭ 15
￭ Connect the Remote Box connection cable to one of the sockets
marked with MSB on the rear of the control device.
￭ Start the control software.
Figure 10 Connecting a Remote Box
You can, for example, connect an 849 Level Control (fill level monitoring
in a canister) or a 731 Relay Box (switch box for 230/110 volt alternating
current sockets and low-voltage direct current outlets). The Remote Box
also has an MSB socket at which a further MSB device, e.g. a dosing
device or a stirrer, can be connected.
You will find precise information concerning the pin assignment of the
interface on the Remote Box in the Appendix (see Chapter 6.3, page
24).
3.4 Connecting USB devices
Additional Metrohm devices, such as USB Sample Processors, Dosing
Interfaces, Titrandos, etc. can be connected to the 859 Titrotherm.
Proceed as follows:
1 Connect one 6.2151.000 connecting cable with one end (8-pin Mini
DIN plug) to the Controller connector of the Metrohm device.
2 Connect the other end of the connecting cable to the connector
USB1 or USB2 of the 859 Titrotherm.