Figure 12, Positioning the thermoprobe – Metrohm 859 Titrotherm User Manual
Page 26
Advertising
3.6 Setting up the titration cell
■■■■■■■■■■■■■■■■■■■■■■
18
■■■■■■■■
859 Titrotherm
1 mm
1 mm
Figure 12
Positioning the Thermoprobe
The sensor should be installed in accordance with the above figure. A high
stirring rate is very important. Please ensure that there is a sufficient
amount of liquid in the vessel so that the sensor is immersed at least 1 cm,
even when the solution is being stirred at high speed. A visible stirring fun-
nel must result.
Advertising