6 setting up the titration cell, Setting up the titration cell – Metrohm 859 Titrotherm User Manual
Page 25
■■■■■■■■■■■■■■■■■■■■■■
3 Installation
859 Titrotherm
■■■■■■■■
17
3.6
Setting up the titration cell
Install the titration cell in accordance with the following figure:
1
6
7
8
2
3
4
5
1
Propeller stirrer (802 Stirrer)
Connect the stirrer to the stirrer connector
on the rear of the titration stand.
2
Sensor Thermoprobe (6.9011.020 or
6.9011.040)
Connect the sensor at T-Port 1 (or T-Port 2)
to the rear side of the 859 Titrotherm.
3
SGJ sleeve (6.1236.050)
SGJ 14/12 mm Material: PE.
4
SGJ intermediate cone (6.2727.010)
For the 802 Stirrer.
5
Stirring propeller (6.1909.010)
L= 96 mm, Material: PP.
6
FEP tubing (6.1805.100)
Connect the tubing (40 cm) to Port 1 on the
dosing unit.
7
Antidiffusion tip M6 (6.1543.200)
L=151 mm, Material: ETFE/FEP.
8
Link stopper (6.1446.030)
Material: ETFE.