Banner FI22 Expert Series - Manual (Page 8)

FI22FP Low-Profile Inline Plastic Fiber Optic Sensor
8
P/N 108899 rev. C
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Specifications
Sensing Beam 660 nm visible red
Supply Voltage 10 to 30V dc (10% max. ripple) @ less than 32 mA exclusive of load
Supply Protection Circuitry Protected against reverse polarity, over voltage, and transient voltages
Delay at Power Up 250 milliseconds max.; outputs do not conduct during this time
Output Configuration Bipolar: 1 current sourcing (PNP) and 1 current sinking (NPN)
Output Rating
100 mA maximum load @25° C (derate 1 mA per °C increase)
OFF-state leakage current: < 50 µA at 30V dc
ON-state saturation voltage:
NPN: < 200 mV @ 10 mA and 1V @ 100 mA load
PNP: < 1.5V @ 10 mA and 2.0V @ 100 mA load
Output Protection
Protected against output short-circuit, continuous overload, transient over-voltages, and false pulse
on power up
Output Response Time 500 microseconds
Repeatability 100 microseconds
Adjustments
2 push buttons and remote wire
• Expert Teach programming (two-point static, dynamic, and single-point static)
• Manually adjust (+/–) thresholds (from buttons only)
• LO/DO and Off Delay configurable (from buttons or remote wire)
• Push-button lockout (from remote wire only)
Indicators
8-segment red bargraph:
Light-to-dark signal difference relative to taught condition (single-point TEACH), or
Sensing contrast (two-point TEACH)
Green LED: Power On
Yellow LED: Output conducting
Construction PC/ABS blend plastic housing; polycarbonate cover
Environmental Rating IP67, NEMA 6
Connections 5-conductor 2 m (6.5') PVC cable, 9 m (30') PVC cable, or 6-pin integral Pico-style quick-disconnect
Operating Conditions
Temperature: -10° to +55°C
Relative Humidity: 90% @ 50° C (non-condensing)
Certifications