Banner FI22 Expert Series - Manual (Page 9)

P/N 108899 rev. C

FI22FP Low-Profile Inline Plastic Fiber Optic Sensor
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
To install fibers:
1. Use a small Phillips screwdriver to loosen set screw, as shown in Figure 6.
2. Insert prepared fiber ends (2.2 mm diameter) into emitter and receiver ports, as far as
they will go.
3. Holding fibers in place, tighten screw to lock in securely.
Installing the Optical Fibers
Sensor and Bracket Dimensions
Figure 6. Installing plastic optical fiber into
the FI22FP fiber ports
50.0 mm
(1.8")
Pico-style
Quick Disconnect
Integral
Cable
23.0 mm
(0.1")
14.5 mm
(0.5")
.0 mm
(0.28")
25.0 mm
(0.8")
6.0 mm
(0.24")
12.1 mm
(0.48")
10.5 mm
(0.41")
Sensor
Bracket