JK Audio BlueSet - Manual (Page 6)

2
Mode Switch
In the Bluetooth world, a Master
device, such as a wireless phone,
computer, or music player, is
connected to a Headset device.
Before you turn the BlueSet on, be
sure to set the <Headset/Phone
Switch> to the correct position. If you
change that switch while the unit is
on, you will need to power the unit off,
then power the unit back on before the
change takes effect.
Select <Headset> if you will be
using your BlueSet with a Bluetooth
enabled headset or any device that
emulates a headset. Select <Phone>
if you will be using your BlueSet with
a cell phone or other master device.
See page 8 for more information on
Bluetooth profiles for different wireless
applications.
Mic Trim
A small flat blade screwdriver can be
used to adjust the <Mic Trim> pot on
the back of the unit. This adjusts the
level of the audio coming from the
Bluetooth wireless technology enabled
device as it is sent into the beltpack
headset connector.
Recording Output
A 3.5 mm stereo output jack contains
a mic level signal suitable for
recording, with the clean mic signal
on the left channel and the Bluetooth
wireless technology return audio on
the right.
Power Rec
Getting To Know your BlueSet