JK Audio RemoteMix 2 - Manual (Page 15)

FAQs
11
8) The output from Mic 2 is very low but the other mics are fine.
Check the position of the <Mic/Line> switch near <Mic 2>. This input can be
switched to accept a line level signal from a mixer or other equipment.
9) How can I tell how much battery life is remaining?
The red <Power> LED functions as a battery life gauge that will gradually dim
as the battery runs down. This red LED will go completely dark about a half
hour before the unit shuts down. Keep in mind that the VU meter will remain
bright until the unit stops functioning.
10) Does the AC power supply charge the batteries?
No. You may use rechargeable batteries, but you must remove and recharge
the batteries outside of the RemoteMix 2.
11) I’ve lost my power supply for my RemoteMix 2 unit. I
have a power supply that fits from a different product. Can I
use this instead?
No. Never use a power supply other than the one that was supplied by your
manufacturer. Power supplies are available in either AC or DC output with
many combinations of voltage and available current. Most consumer power
supplies are not regulated. This could invariably damage your equipment, and
also create a great deal of noise. Our products are designed for and tested
with their respective power supplies for optimum operation. If you have lost
your power supply, please contact your JK Audio dealer or our Customer
Service department and ask for a PS009 power supply for your RemoteMix 2.
FAQs