Reloop SPIN!2 - Manual (Page 53)

ENGLISH
53
a) Connect your turntable‘s or CD player‘s outputs to the corresponding inputs (1 or 2) of the
Reloop Spin! 2 Interface -1-. If required connect your turntables to the GND grounding screw -3-.
Depending on the connected player de-/activate the phono pre-amp.
b) Connect the line outputs -6- of the Spin! 2 Interface with the line inputs of your mixer. In order to
loop through a conventional vinyl signal connect the Through Outputs -7- with the phono inputs
of your mixer. This way it is possible to switch between the timecode and analogue vinyl signal by
simply using the phono/line switches.
NOTE!
The Signal Input LEDs 1, 2 -8- light up when there is an incoming signal. The Signal Output
LEDs light up when there is an outgoing signal.
c) Connect the enclosed USB cord to the USB Port -4- of your Spin! 2 Interface and a free USB port
of your computer. Now the following messages should appear on your monitor (example for XP):
(New hardware found – Reloop Spin! 2 Interface)
(New hardware found – USB audio device)
(New hardware found – Your new hardware is installed and ready to use.)
NOTE!
The basic installation of your Spin! 2 Interface under Windows XP & Vista is carried out as Plug
‚N‘ Play without the need for special drivers.
CONNECTIONS