Teradek Bond - Manual (Page 3)

Version 2.0 Jun ‟12 © Teradek, LLC 2012. All rights reserved.
Page | 3
3. To power Cube from Bond, connect the included or 2 pin to 2pin (for Cube x55 encoders) 2 pin to
4 pin (for Cube x00/x50 encoders) power cable from Bond‟s „DC Loop‟ to Cube‟s LEMO
connector marked „6-28 DC Input.‟
Cube front plate (Cube 155 encoder shown):
4. Connect your video source to Cube via BNC cable (SD/HD-SDI, 1xx models) or HDMI cable (2xx
models).
5. Attach the antenna(s) to Cube (if applicable) via the threaded RP-SMA connector.
6. Use the included hot shoe mount and/or ¼ ” screw to mount Cube and Bond to your camera,
tripod mount, or other accessory mount, if desired.
7. Once Cube has booted, verify that the „ENC‟ and „VID‟ LEDs are green, indicating video is
successfully detected.
For more information about Cube‟s physical connections and power options, please refer to the full Cube
reference manual (available on the included USB drive).
Connect to Cube and Bond
Initial set up for wireless-equipped Cubes (x50 models) can be done via Cube‟s Ad Hoc wireless network.
For Cube models without wireless (x00 models), connect an Ethernet cable between Cube and your
computer. For other network configurations, please refer to the Cube Reference Guide.
1. Ad Hoc instructions
1.1. Connect video and power to your Cube Encoder (see the previous section).
1.2. On your computer, open your wireless networking utility.