Teradek Bond - Manual (Page 4)

Version 2.0 Jun ‟12 © Teradek, LLC 2012. All rights reserved.
Page | 4
1.3. Choose your Cube from the list of WiFi devices in your area and connect to that network.
2. Log in to Cube
2.1. Launch TeraCentral (included on the USB drive), and click the „Configure Settings‟ button next to
your Cube‟s listing. Your web browser will open to Cube‟s web UI.
2.2. If the Wizard appears , click „Skip the Setup Wizard.‟
2.3. Log in to Cube with the username „admin‟ and password „admin.‟ Cube‟s Dashboard will appear.
Configure Bond and Sputnik Streaming
Configuration options for the Bo nd and Sputnik streams are located on the „Video Setup‟->‟Stream
Settings‟ page. We recommend setting up your Sputnik server before proceeding with this configuration.
For instructions on installing and running Sputnik, please refer to the separate “Sputnik Installation and
Configuration Guide.” The Bond and Sputnik configuration options are only displayed when Bond is
connected to Cube.
PLEASE NOTE: A software license must be installed on your Cube to activate the Bond configuration
options. If you purchased your Cube with Bond this license should be pre-installed. If Bond is purchased
separately, please contact Teradek to obtain the license.
1. Configure Sputnik Settings
1.1. These settings specify the Sputnik server location and parameters for the between Bond and
Sputnik.