Winchester Repeating Arms 9410 Top Tang Safety (Historic Manual) - Manual (Page 35)

post mounting stud, note the two different sized holes in
the end of the magazine tube (Figure 31).
The larger hole
must face away from the barrel.
8. Replace magazine tube onto sling post mounting stud.
9. Replace sling post through magazine tube and end cap.
Carefully install sling post making sure the largest part of
sling post is properly installed and passes through the hole
in the magazine tube. Failure to do so will cause damage
to the magazine tube.
10. Return forearm cap to original location and secure
forearm cap with screws.
A DAPTER R EMOVAL , M ODEL 9410 P ACKER —
1. Place the safety in the “on safe” position and fully
unload your Model 9410.
2. Remove the two screws on the front of forearm cap
using a standard screwdriver.
3. Pass a small screwdriver through the hole in the sling
post found on the end of the magazine tube. Turn the post
counterclockwise to loosen the post (Figure 29).
4. Slide forearm cap forward on magazine tube. Carefully
remove the magazine end cap from the magazine by
tilting the magazine tube away from the barrel enough
to clear the sling post mounting stud on the barrel (Figure
30).
Remember, magazine cap is under spring load.
5. As the spring rises out of the magazine tube, it will lift
the three-shot adapter with it. Remove the three-shot
adapter from the spring (Figure 28).
6. Replace magazine end cap, pushing the spring back
down into the magazine tube (Figure 31).
Be sure to
install the end cap with the flat spot around the sling post
mounting stud hole facing away from the barrel.
7. Before tilting the magazine back in place on the sling
post mounting stud, note the two different sized holes in
the end of the magazine tube (Figure 31).
The larger hole
must face away from the barrel.
8. Replace magazine tube onto sling post mounting stud.
9. Replace sling post through magazine tube and end cap.
Carefully install sling post making sure the largest part of
the sling post is properly installed and passes through hole
in magazine tube. Failure to do so will cause damage to
magazine tube.
35
Flat spot of end cap
faces away from barrel
FIGURE 31
Larger hole in magazine
tube faces away from barrel
02-224-WFA_9410_OM_revis 7/16/03 2:52 PM Page 35