Dymo LetraTag QX50 - Manual (Page 5)

What the DYMO LetraTag
QX50 can do for you
With the LetraTag QX50 you can print a wide
range of high-quality labels in different sizes
and styles. You type using the familiar layout
of a traditional keyboard. The QX50 can print
on coloured, transparent, metallic and iron-
on fabric tapes. See the list of Dymo cas-
settes available for the LetraTag QX50 at the
end of this guide.
How to use your DYMO
LetraTag QX50
Getting started: your first label in 6 easy steps
Step One - insert the batteries
- Remove the battery cover (Fig A)
- Insert five size AA alkaline batteries,
observing the polarity markings. Start with
the single battery in the upper slot, then slide
the second and third under bridge. Slot in the
fourth and fifth batteries and close the cover.
- Remove the batteries if the Letra Tag is to
remain unused for some time.
Step Two - insert the cassette
Press the catch to open the cassette door.
Insert cassette (Fig B) and gently press on
the centre of the cassette until it clicks into
place (Fig C).
Check the cassette is correctly positioned
before closing the cassette door.
Step Three - switch on
Press the red button to switch on.
Note: the label maker switches off automati-
cally after 2 minutes if no keys are pressed.
Step Four - type a label
Type a simple label first to try the machine.
Learn more about formatting in the following
pages.
Step Five - Print your label
Press to print your label.
Step Six - Cut the label
Use the cutter button on the left-hand side
of the LetraTag to cut the label (Fig E).
Congratulations ! You’ve just printed your
first label !
PRINT
5
UK
LTQX50 WEU.qxd 12-09-2002 11:07 Pagina 5