Monarch Instrument Navigator - Manual (Page 14)

Navigator Software User‟s Manual
Page 14 of 20
There are two edit boxes on the dialog that specifies the channel tag in different colors as shown below:
The colors match the channel trace colors. If the user changes the trace color, the corresponding edit box
will change color accordingly. If the user double-clicks one of them, that trace will zoom to fit the screen in
the vertical direction. The fit is
– minimum value is placed at the bottom of the graph, maximum value at
the top. Use the zoom and stretch tools above to fine-tune the fit.
3.5.3 CUSTOMIZING THE GRAPH PROPERTIES
You can modify the graph properties by right-clicking the mouse in the graphics area. A menu appears as
shown below.
The user can modify Channel A or B properties, change the color of the background, or turn the grid on or
off. Moving the cursor over the Channel A item pops up the Setup window. Click on this to modify the
Channel A properties.
The trace can be turned off by selecting Disable. This will allow a single trace to be displayed.
If a trace is enabled it can be customized as follows:
Marker Type
– Identifies the actual points recorded. The trace is extrapolated between these points. The
points can be marked by a square, circle, or diamond, and the size can be adjusted. No marker can also
be selected.
Line type
– Can be solid, dashed, or dotted. The thickness and color can be selected to suit.
The Alarm section of the Channel Setup Dialog allows the display of alarm conditions provided alarms
were set on the original data capture. Enable or disable the Alarm by checking the appropriate button.
The Alarms pull-down menu will show any alarms that were set in the original recording. These will be
identified as Alarm 1, 2 and so on. You can select how these alarms will be indicated.
Go to Contents