Monarch Instrument Navigator - Manual (Page 9)

Navigator Software User‟s Manual
Page 9 of 20
In the lower right corner the date the data was recorded, the recorder identification and sample rate are
displayed. This sample recording was started on Tuesday, November 08, 2005 at 2:49:48 PM. The sample
rate was 20 Samples/Sec and the recorder was identified by the UNIT TAG.
The summary information for each channel is displayed in the workspace section. By clicking on Minimum or
Maximum you can jump directly to those points on the graph.
3.3.1 LOADING PARTIAL FILES
When opening files from the recorder,
large files can take a long time to load.
You can simply download the period
of interest without the need to load the
entire file. So if you need information
for 12:00PM to 3:00PM on May 11
th
,
2006, you can request only this data –
assuming it is in the data file you have
chosen. Make sure Use Recorder has
been checked
– see above , and go to
File – Open.
The Copy File dialog box will open as
shown right showing files on the
remote recorder. Data files are type
.DAT.
Once you select a file and click OK you will get the
Time Filter dialog box. If the Whole File box is
checked you can click OK to load the entire file.
Otherwise, uncheck this box and edit the Start: and
End: times for the data you want. Click OK. If the data
you are looking for is in the file, the information will be
loaded; otherwise you will get an error message telling
you that no such data can be found. Thus you can
leave a recorder to record events and simply download
the data when an exception occurs.
Go to Contents