Great Plains ADC1150 Operator Manual - Manual (Page 21)

19
Section 1 Cart Assembly and Setup
7/28/10 Model 1150 1995 - 1997 167-058M
Great Plains Mfg., Inc.
Lower Ladder Weldment
and Lower Ladder Support Weldment
Refer to Figure 1-8:
Install the lower ladder support weldment (#8) to the rear
of the cart with the 1/2”-13 x 3 1/32” x 4” u-bolts (#1), 1/2”
lock washers (#2), and 1/2” nuts (#3). Attach the lower lad-
der support so that the longest edge, along the mounting
plates, is on the bottom and that the mounting plates face
toward the front.
Be sure that the lower ladder support weldment is cen-
tered from side to side before tightening the u-bolts.
Install the left hand lower ladder weldment on the left side
of the drill using four 1/2” x 3” bolts (#5) with the 1/2” lock-
washers (#7), and the 1/2” nuts (#6). Install the bolts so
that the nuts are toward the center of the ladder. Use this
procedure for installing the right side ladder.
NOTE: The lower ladders are identified left and right
by orienting them so that the handrails are located to-
ward the outside of the drill, refer to Figure 1-8.
Slow Moving Vehicle
Bracket & Emblem
Bolt the slow moving vehicle (SMV) support bracket (#9) to
the center of the lower ladder support weldment (#8)
using one 3/8” x 3 1/32” x 4” u-bolt (#10), the 3/8” lock
washers (#11), and 3/8” nuts (#12). Install the bracket on
the rear edge of the tube with the remaining holes in the
bar on the top. Attach the SMV emblem and bracket to the
support using the supplied hardware. Install the SMV
bracket with the offset to the rear.
Lower Ladder Installation
Figure 1-8
14463