Great Plains ADC1150 Operator Manual - Manual (Page 47)

45
Section 3 Operating Instructions
7/28/10 Model 1150 1995 - 1997 167-058M
Great Plains Mfg., Inc.
•
Remember that the bin obstructs a portion of your view
to the rear. Be prepared for sudden maneuvers from fol-
lowing vehicles.
Parking
The following steps should be done when parking the drill.
Refer to Storage under the “Maintenance and Lubrication”
section on page 69 for information on long term storage
preparation.
1. Raise and lock implement in storage position.
2. Place the drill on a firm, level area.
3. Remove jack from storage position and pin securely to
lifting stob on outside of tongue.
4. If ground is soft place a wide block or plate under the
jack to increase the contact area.
5. Securely block the drill tires to prevent rolling.
6. Extend the jack until the weight is off of the tractor
drawbar.
7. Unhook electrical lines and install plugs as provided.
8. Release pressure on hydraulic system, then discon-
nect hydraulic lines and pull all lines back onto the drill
tongue. Be sure the ends do not rest on the ground.
9. Remove the drawbar pin and then disconnect the
safety chain.