Canon LV-X2 - Manual (Page 15)

15
BEFORE OPERATION
Pull out Battery Holder.
Replace with new battery. Install
with battery (+),(–) marks properly. Install battery and
Battery Holder into
Remote Control Unit.
BATTERY
LITHIUM BATTERY
CR2025 (3.0V)
(+) mark indicates
its (+) polarity.
Put Battery + mark
as shown direction.
BATTERY HOLDER
REMOTE CONTROL UNIT BATTERY INSTALLATION
To insure safe operation, please observe the following precautions :
● Use only specified battery. Improper battery may cause malfunction of Remote Control Unit.
● Be sure to install battery with correct polarity.
● Do not expose a battery to moisture or heat. Do not charge a battery.
● If a battery has leaked on the Remote Control Unit, carefully wipe the case clean and load a new battery.
● Keep a battery away from children to avoid swallowing it accidentally.
● Risk of explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
1 2 3
30
°
30 °
Point Remote Control Unit toward projector (Receiver
Window) whenever pressing any button. Maximum
operating range for Remote Control Unit is about 16.4’ (5m)
and 60° in front of the projector.
16.4’
(5 m)
OPERATING RANGE