Casablanca Fan Company PN - Manual (Page 7)

7
B
rescia
®
Step 11. Attach the blades to the blade
holders by first pressing the blade badge
into the blade, then installing the blade
holder using the four blade screws and flat
washers provided for each blade.
Using the screwdriver, tighten securely
by hand only.
Repeat for each blade assembly.
BlADE SCREw
(4 pER BlADE)
BlADE
BlADE
holDER
BlADE InSTAllATIon
BlADE SCREw (4
pER BlADE)
BlADE & BlADE holDER hARDwARE
BlADE
holDER
BlADE holDER
SCREw
(2 pER BlADE)
Step 10. To reach the blade holder mount-
ing holes in the fan motor the dummy switch
housing must be removed.
Take out the two 5-32 X 9 /
32
” screws securing
the dummy switch housing and remove. Set
the two (2) screws aside for the moment, they
will be used in Step 15 to install the switch
housing after the blades are installed.
The dummy switch housing is used only when
shipping the fan.
InSTAllIng ThE BlADE/BlADE holDER To fAn moToR
pREpARATIon
DUmmy
SwITCh
hoUSIng
Note: Save these two screws–
they will be used in Step 15.
BlADE
BADgE