Casablanca Fan Company PN - Manual (Page 9)

9
B
rescia
®
InSTAllIng ThE SwITCh hoUSIng ASSEmBly
Step 17. Line up the two clearance holes
in the cap with the two threaded holes on
the raised rim of the switch housing. Press
the cap onto the switch housing to seat the
guide pins into the alignment holes of the
switch housing.
Step 18. Using the two (2) 8-32 X 3 /
8
″
screws removed in Step 14, install the cap
onto the switch housing.
Tighten securely by hand only.
InSTAllIng ThE CAp
Step 15. Attach the two (2) 5-32 X 9 /
32
″
switch housing screws removed in Step 10
(on Page 7) to fan motor as shown,
leaving 1 ⁄
8
” space for the switch housing
installation.
Step 16. Lift the switch housing, run-
ning the switch housing screws through
the keyholes. Turn the switch housing
right (clockwise) to engage the keyholes.
Tighten securely by hand only.
CAp SCREw
8-32 X 3 /
8
″
(2)
SwITCh hoUSIng
moUnT SCREw
5-32 X 9 /
32
″
(2)
KEyholE
SwITCh hoUSIng pREpARATIon
Step 14. Locate the switch housing/cap as-
sembly and remove the two 8-32 X 3 /
8
″ screws
holding the cap onto the switch housing.
CAp
SwITCh
hoUSIng
CAp SCREw
8-32 X 3 /
8
″
(2)
Note : Save these two screws–
they will be used in Step 18!