Apricorn Aegis Bio - USB 2.0 - Manual (Page 17)

www.apricorn.com 17
Fingerprint Tutorial
Strip sensors represent a new type of fingerprint scanner. To help you
with your enrollment, we created a tutorial where you can practice
swiping your finger to create fingerprint samples.
To run the fingerprint tutorial:
The tutorial is included in the Protector Suite Token Enrollment Wizard,
but in the event that you would like to run it again after enrollment
please follow the steps below.
Right-click on the Protector Suite Token icon in the system tray on 1.
the lower right corner of your desktop.
Select Fingerprint Tutorial. 2.
The animation in the tutorial shows the correct movement of
the finger across the sensor:
Position the last knuckle joint (closest to the tip of your finger) •
over the sensor.
Maintain finger contact with the sensor while sliding the finger •
towards you in a straight line.
Make sure to keep the finger in a flat position as you move it over •
the sensor.
On the next page of the tutorial, we have created a practice •
session for you to perfect the swipe method.
Settings
To display the Settings dialog:
1. Click the Protector Suite Token tray icon and select Settings from
the menu.
2. Swipe your finger over the sensor to verify your identity.
3. Select one of the appropriate tabs.
General Options Tab
To set general application options:
Set the desired status of check boxes in the General section. •
Set the biometric hot key for the Password Bank and (optional) •
fingerprint logon. This combination of keys invokes fingerprint logon,
web page registration, or replaying of a registered page. (To register
an already registered page, use it together with Shift.)