B&G Network Autopilot - Manual (Page 60)

4 - 12
BLUE RAM SOLENOID WIRING DETAILS
The following information applies to the Size 1, Size 2 and Size 3 Blue
Rams only.
1.
Remove the solenoid wiring connector by unscrewing the centre
screw.
2. Remove the screw from the connector housing.
3. Remove the rubber gasket.
4.
Use a small screwdriver through the screw hole to carefully push
against the connector block. This will push the front of the connector
block out ready for wiring.
5. Run the cable through the cable entry in the cover and then connect
as follows:-
Pin 1 Blue Wire
Pin 2 Brown Wire
6. The cable screen must be cut back and sleeved.
Connect the two halves of the connector back together, tighten the
plastic cable clamp nut, replace the rubber seal and refit the connector
onto the solenoid using the centre screw to fully secure it.