B&G Network Autopilot - Manual (Page 74)

5 - 5
LINEAR FEEDBACK UNIT INSTALLATION
1. Ensure that the Linear Feed back unit is firmly clamped to the
side of the Linear actuator using the bracket kit supplied.
2. Check to see the shaft of the Linear Drive Unit has sufficient
lubrication,
use only high quality grease.
3. Ensure that the Ram stroke does not exceed the stroke of the
Linear Feedback Unit.
COMPASS INSTALLATION
1. Clear of sources of magnetic interference, including power cables to
other equipment, if in doubt check 1 metre around with small hand
compass. Look on the other side of the bulkhead!
....❒
2. Fitted as near to centre of motion of boat as other factors allow, aft
of centre preferred because usually less motion than fore of centre
.....................................................................❒
ELECTRONICS INSTALLATION
1. Cables secure ..............................................❒
2. Cables
undamaged ......................................❒
3. No loose bits of wire.....................................❒
4. Screens connected in accordance with wiring instructions and
sleeved where appropriate...........................❒