B&G Network GPSplus - Manual (Page 16)

16
ENTERING WAYPOINTS BY LATITUDE AND LONGITUDE
1. Select a point on a
chart, determine the
latitude and longitude.
Press the WPT/MOB key. 2. Press the SETUP key.
Turn the ▼ STEP ▲ knob
to select an empty WPT
number. 3. Press the ENTER key.
The DEGREES of latitude
will flash.
Use the ▼ STEP ▲ knob
to change the degrees. 4. Press the ENTER key.
The MINUTES of latitude
will flash.
Use the ▼ STEP ▲ knob
to change the minutes.
5. Press the ENTER key.
The 10ths and 100ths of
MINUTES will flash.
Use the ▼ STEP ▲ knob
to change the value. 6. Press the ENTER key.
The 1000ths of MINUTES
will flash. Use the ▼ STEP
▲ knob to change the
value. 7. Press the ENTER key.
The N or S will flash.
Use the ▼ STEP ▲ knob
to select N or S.