B&G Network GPSplus - Manual (Page 54)

55
COG AND SOG DAMPING
This is the damping factor applied to Speed and Course
Over the Ground. When set to AUTO more damping is
applied when SOG is low, to prevent display jitter.
1. Press
the POS key.
2. Press the SETUP key until COG SOG is displayed. The
setting for damping will also be displayed.
3. Press
the ENTER key, the display will now flash.
4. Use
the ▼ STEP ▲ knob change the damping.
5. Press
the ENTER key to memorise the setting.
CALCULATION METHOD FOR BEARINGS
This setup is the method used by the unit to calculate
bearing and distance in NAV mode. The unit can be set to
use either Rhumb Line or Great Circle. Select the one most
suitable for your navigational needs.
1. Press
the POS key.
2. Press the SETUP key until bEArInGS is displayed. The
current setting will also be displayed.
3. Press
the ENTER key, the display will now flash.
4. Use
the ▲ STEP ▼ knob change the setting.
5. Press
the ENTER key to memorise the setting.
SEtUP
COG SOG
DAMPING OFF
SEtUP
bEArInGS
RHUMB LINE