B&G Network GPSplus User Manual
Page 22
22
ENTERING WAYPOINT BY RANGE AND BEARING FROM PRESENT POSITION
1. Press the WPT/MOB key.
Use the ▼ STEP ▲ knob to
view the waypoint library.
2. Press the SETUP key 5
times. The display will show
WPT### BY RB. Use the ▼
STEP ▲ knob to select a
WPT number.
3. Press the ENTER key.
The range in nautical miles
will flash. Use the ▼STEP▲
knob to enter the range from
0.01 to 9.99nM.
4. Press the ENTER key.
The bearing in degrees will
flash. Use the ▼ STEP ▲
knob to enter the bearing
from 000° to 359°.
5. Use the ▼ STEP ▲ knob
to select a waypoint (from
the library) to calculate the
range and bearing from. For
example BUOY WPT 1 is
used.
6. Use the ▼ STEP ▲ knob
to select a waypoint library
location for the new
waypoint. Press the ENTER
key to memorise the new
range and bearing.
7. Press the WPT/MOB key
twice to display the latitude
and longitude of the
waypoint. The waypoint can
be named if required.