B&G Network GPSplus - Manual (Page 28)

29
DEFINING A ROUTE
The route in the diagram on the previous page is used in
the following example.
When the waypoint library has been set to sort by name, the
display will only show the first six characters of any named
waypoint. If the waypoints in your library have not been
named then the waypoint number will be shown e.g. W001.
When sort by number is selected then the WP number is
displayed.
1. Press the ROUTE key.
Select a route to define
using the ▼ STEP ▲ knob. 2. Press the SETUP key to
begin route entry. END will
flash. When the right side
of the text display is
flashing, waypoints can be
selected from the library.
The start of a route is
always from your present
position PPOS. 3. Turn the ▼ STEP ▲
knob to cycle through the
waypoints in the library
until the desired waypoint
is displayed e.g. MOORIN. 4. Press the ENTER key to
select the displayed
waypoint. The selected
waypoint will now appear
on the left of the display.