BE Pressure supply 30 Gallon Diesel Compressor / Welder / Generator AC1030K5000W - Manual (Page 11)

11
Receiving and Uncrating of your Compressor
Before uncrating the compressor the following steps should be taken.
1. Immediately upon receipt of the equipment, it should be inspected for
damage that may have occurred during shipment. If any damage is
found, demand an inspection immediately by an inspector from the
carrier. Ask him how to file a claim for damages. (See Appendix “A” for
Details).
2. Insure that adequate lifting equipment is available for moving the
machinery.
3. Read the compressor nameplate to be sure the compressor is the
model and size ordered.
4. Read the motor nameplate to be sure the motor is compatible with
your electrical conditions. (Volts-Phase-Hertz).
Compressor Installation
LOCATION
Locate the compressor in an area that is clean, dry, well lighted, and
well ventilated, with sufficient space for safe and proper inspection and
maintenance. Ambient temperatures should not exceed 110 degrees F
or fall below 30 degrees unless. Inspection and maintenance checks are
required daily, therefore, ample space is required around the compressor.
The compressor must not be installed closer than fifteen inches from a
wall or other solid structure to allow ample circulation or air across the
compressor cylinders and head, and through the coolers if they are part
of the system. Additional safety can be achieved by locating the pulley
guard next to the wall or solid structure.
MOUNTING
We recommend the use of rubber pads or isolators between the tank
legs and the floor. If a shim is required to level the unit, place it between
the pad and floor. If you bolt the unit to the floor, use the bolts as guide
pins and do not tighten the bolts. The rubber pads are used to absorb
machine vibration and cannot work effectively if bolted tightly.
pre
-
operation
IMPORTANT: Compressor drive engine comes with its own manual
refer to drive engine manual for any specifications or troubleshooting
issues with the drive engine of the air compressor.
WARNING
Improper lifting can result in component or system damage or personal
injury. Follow good shop practices and safety procedures.