BE Pressure supply 30 Gallon Diesel Compressor / Welder / Generator AC1030K5000W - Manual (Page 14)

14
DRIVES
It is important that the compressor and motor pulleys are aligned properly
and the V belt is correctly tensioned. Improper pulley alignment and belt
tension are causes for motor overloading, excessive vibration, and prema-
ture belt and/or bearing failure.
CAUTION
Removal or painting over safety labels will result in uninformed condi-
tions. This may result in personal injury or property damage. Warnings
signs and labels shall be provided with enough light to read, conspicu-
ously located and maintained for legibility. Do not remove any warning,
caution, or instructional material attached!
Provisions should be made to have the instruction manual readily avail-
able to the operator and maintenance personnel. If for any reason any
part of the manual becomes illegible or if the manual is lost, have it re-
placed immediately. The instruction manual should be periodically read
to refresh one’s memory, it may prevent a serious or fatal accident.
pre
-
operation
CAUTION
Excessive speed of the compressor or driver can be lethal. Never
operate the compressor beyond the manufacturer’s recommendation.
Bursting of the flywheel may be the greatest threat because the normal
guard may not contain all the pieces. Crankshaft and connecting rod
breakage is a possibility and compressor efficiency, valve life and bear-
ing life will be abnormally reduced.
GUARDS
All mechanical action or motion is hazardous in varying degrees and
needs to be guarded. Guarding shall be in compliance with OSHA Safety
and Health Standards 29 CFR 1910.219 in OSHA manual 2206 and any
state or local code.
CAUTION
Guards must be fastened in place before starting the compressor and
never removed before cutting off & locking out the main power supply.